K 1500 Truck 4WD V8-350 5.7L (1986)
Figures 9 and 10
Change to Assembly Components: (Figures 7, 8, 9 and 10)
New Lo and reverse clutch assembly for all models that contain:
-
New lo and reverse clutch wave plate (682 B)
-
5 lo and reverse clutch plate assemblies (fiber)
-
4 lo and reverse clutch plates (steel)
-
New selective spacer plate (682A)
-
New retainer and ball assembly (106) added to reverse apply passage
-
In rear of case (Figure 9)
-
New lo and reverse clutch piston with shorter apply skirt (Figure 10)
Procedure for selection of the lo and reverse selective backing plate (Figure 7)
1. On a flat work surface, stack up the following lo and reverse clutch assembly parts:
-
1 waved plate
-
5 fiber plates and four steel plates (682), starting with one fiber plate and alternating with a steel plate
-
lo and reverse clutch support assembly (679)
2. Apply an evenly distributed load to the top of the lo and reverse support assembly (679). Light pressure (5 lbs.) on the lo and reverse support
assembly (679) will provide the correct dimension for measurement. (Caution: excessive pressure will start to flatten the wave plate, resulting in an
inaccurate measurement.)
3. Measure height of clutch pack from work surface to the top of lo and reverse clutch support (679). Refer to Figure 7, Dimension "D".
4. Use dimension "D" (Figure 8) to select proper thickness of the selective spacer plate for assembly.
5. Install the proper selective spacer plate between the wave plate and first fiber clutch plate with the identification facing up.
6. The overall height for dimension "D" with the selective spacer plate included should be 30.515 mm - 31.401 mm (1.20" - 1.24").
SERVICE ACTION:
The new lo and reverse clutch assembly components may be used on all 1982 through 1987 transmissions only if all the new service parts and
procedures for selection of the clutch pack clearance are used during assembly.
SERVICE PARTS INFORMATION:
