K 1500 Truck 4WD V8-379 6.2L DSL VIN J FI (1992)
![background image](/gmc/k_1500_truck_4wd/v8-379_6.2l_dsl_vin_j_fi/Page-2083026.png)
Fig. 6 Wire Size Conversion Table
Step 3: Strip the Insulation
If it is necessary to add a length of wire to the existing harness, be certain to use the same size as the original wire, see Fig. 6. To find the correct
wire size either find the wire on the schematic and convert the metric size to the equivalent AWG size or use an AWG wire gage. If unsure about
the wire size, begin with the largest opening in the wire stripper and work down until a clean strip of the insulation is removed. Strip
approximately 7.5 mm (5/16 in.) of insulation from each wire to be spliced. Be careful to avoid nicking or cutting any of the wires. Check the
stripped wire for nicks or cut strands. If the wire is damaged, repeat this procedure after removing the damaged section.
Crimp And Seal Splice Sleeve Chart
Fig. 13 Hand Crimp Tool