K 1500 Truck 4WD V8-5.3L VIN T (2000)
1. Use a soft spray of water in order to watertest the stationary window immediately.
2. Warm or hot water is preferred in order to accelerate the cure of adhesive.
3. Do not direct a hard stream of high pressure water at fresh urethane adhesive.
Important: Inspect the stationary window for leaks.
29. If any leaks are found, use a plastic paddle in order to apply extra urethane at the leak point.
Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.
Caution: Repair Material Curing Caution in Service Precautions.
30. Retest stationary window for leaks.
31. In order to properly cure the urethane adhesive, do the following:
*
Allow the vehicle to remain at room temperature of 22°C (72°F) at 30 percent or less relative humidity.
*
Allow a minimum of 6 hours for the moisture curing urethane adhesive.
*
Allow a minimum of 1 to 1 1/2 hours for the chemical curing urethane adhesive.
*
Partially lower a door window to prevent pressure build ups when closing doors prior to urethane adhesive cure.
*
Do not drive the vehicle until the urethane adhesive is cured.
*
Do not use compressed air in order to dry the urethane adhesive.
32. Remove the tape from the painted surfaces.
33. Connect the defogger clips on each side of the window on the inside to the body connectors, if equipped.
34. Install all trim panels which were removed in order to gain access for rear window removal.
35. Remove the protective coverings and tape from the vehicle.
