K 1500 Yukon 4WD V8-4.8L VIN V (2003)
7. Install the transmission control lever to the manual shaft with the nut.
-
Tighten the nut to 25 Nm (18 ft. lbs.).
8. Connect the PNP switch electrical connectors (2).
9. If equipped with 4WD, install the front propeller shaft.
10. Lower the vehicle.
11. Check the switch for proper operation. The engine must start in the park (P) or neutral (N) positions only. If proper operation of the switch can not
be obtained, replace the switch.