K 1500 Yukon 4WD V8-5.3L VIN T (2000)
5. Remove the upper shock absorber nut and the bolt.
6. Remove the lower shock absorber nut and the bolt.
7. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the upper shock absorber nut and bolt.
3. Install the lower shock absorber nut and bolt.
-
Tighten the nuts to 95 Nm (70 ft. lbs.).
4. Connect the electrical connector and air line if equipped with RTD.
5. Connect the RTD sensor (if equipped). Refer to Rear Position Sensor Replacement - Electronic Suspension - Left (15 Series) or Rear Position