K 1500 Yukon 4WD V8-5.3L VIN Z Flex Fuel (2003)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor (CMP)
REMOVAL PROCEDURE
1. Remove the intake manifold.
IMPORTANT:Clean the area around the CMP sensor before removal in order to prevent debris from entering the engine.
2. Remove the camshaft position (CMP) sensor bolt.
3. Remove the CMP sensor.
Camshaft Position Sensor (CMP)
INSTALLATION PROCEDURE
1. Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions See: Service Precautions/Vehicle Damage Warnings/Fastener Notice.
2. Install the CMP sensor bolt.
Tighten
Tighten the bolt to ......................................29 N.m (21 lb ft).
3. Install the intake manifold.