K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
7. Apply a small bead of urethane adhesive (2) between the windshield (1) and the pinchweld.
8. Install the upper reveal molding.
1. Start from the center and hand-press the reveal molding into place over the edge of the windshield.
2. Install the right and the left sides of the reveal molding.
3. Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
4. Apply the tape in order to retain the reveal molding to the windshield. This will maintain a flush fit with the body.
5. Remove the tape after 6 hours.
