K 1500 Yukon XL 4WD V8-5.3L VIN T (2001)
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle.
3. Remove the upper shock absorber nut and the bolt.
4. Remove the lower shock absorber nut and the bolt.
5. Lower the rear axle to allow the removal of the shock absorber.
6. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the upper shock absorber nut and bolt.
3. Raise the rear axle to allow the installation of the lower through bolt.
4. Install the lower shock absorber nut and bolt.
-
Tighten the nuts to 95 Nm (70 ft. lbs.).
5. Remove the support from the rear axle.
6. Remove the safety stands.
7. Lower the vehicle.
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap
ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
Caution: To prevent personal injury, wear safety glasses when centerpunching and drilling the shock absorber. Use care not to puncture the shock
absorber tube with the centerpunch.
