K 1500 Yukon XL 4WD V8-5.3L VIN T (2001)
^
The front or rear half of the shift cable can be removed without removing the other half.
^
Perform the installation procedure that applies to the installation of that half of the shift cable.
29. Position the steering column shift lever to the park position.
30. Raise the vehicle. Refer to Vehicle Lifting.
31. Ensure the transmission manual shaft is positioned to the mechanical park.
32. Install the shift cable to the transmission bracket.
33. Install the retainer securing the shift cable to the transmission bracket.
34. Install the shift cable end to the transmission shift lever ball stud.
35. Grasp the front half (cab end) of the transmission cable (1) in the left hand and the rear half (transmission end) of the transmission cable (2) in the
right hand.
36. Align the outside diameter of cable (2) with the inside of the diameter of cable (1).
37. Push the end of the shift cable (2) inside the end of shift cable (1) until the blue spring on shift cable (2) is fully compressed. Pushing together the
two ends of the shift cable will engage the inner wire and lock both cable wires together.