K 2500 Suburban 4WD V8-454 7.4L (1994)
8. Signal switch arm (9) and screw (8).
TIGHTEN
^
Tighten screw (8) to 2.3 Nm (20 lb.in.).
9. Hazard knob assembly and multi-function lever.
10. Thrust washer (12).
11. Upper bearing spring (6).
12. Turn signal cancelling cam assembly (5).
^
Lubricate with grease, synthetic (service kit).
13. Shaft lock (4).
14. New shaft lock retaining ring (3) using J 23653-C to push down shaft lock (4).
^
Ring (3) must be firmly seated in groove on shaft.
15. Shaft lock cover (2).
NOTICE: Gently pull lower turn signal wires to remove any wire kinks that may be inside steering column assembly. Failure to do so may cause
damage to wire harness.
16. Refer to "STANDARD STEERING COLUMN (FLOOR SHIFT)" to complete remaining steering column assembly.
17. Negative (-) battery cable.
Lower Column - Column Shift
INCLUDES:
ADAPTER & BEARING ASSEMBLY
GEARSHIFT LEVER BOWL ASM
SHIFT TUBE ASSEMBLY
BOWL LOWER BEARING
TOOLS REQUIRED:
^
J 23653-A Lock Plate Compressor
IMPORTANT
^
Before doing any service procedures in this section, removal of Steering Wheel is needed.
REMOVE OR DISCONNECT