K 2500 Truck 4WD V8-350 5.7L VIN K TBI (1995)
Window Regulator: Service and Repair
Front Window Regulator and Motor Assembly
Front Door Window Regulator Assembly
Note: The power window motor can not be serviced. It is replaced as a unit with the regulator.
Tool Required: J 34940 Rivet Gun
Remove or Disconnect
1. Trim panel. Refer to Trim Panel. See: Body and Frame/Doors, Hood and Trunk/Doors
2. Water deflector. Refer to Inner Panel Water.
3. Inner mounting panel assembly. Refer to Inner Mounting Panel.
4. Rivets securing the regulator to the door inner panel. Drill out (2) front and (2) rear rivets.
5. Regulator from inner panel.
Install or Connect
1. Regulator to inner panel.
2. Rivets securing the regulator to the door inner panel using J34940.
3. Inner mounting panel assembly. Refer to Inner Mounting Panel.
4. Water deflector. Refer to Inner Panel Water Deflector.
5. Trim panel. Refer to Trim Panel.