K 2500 Truck 4WD V8-379 6.2L DSL (1988)
Removing The Shaft Nut
^
Clamp J 33026 in a vise and attach the compressor to the holding fixture with thumb screws.
1. Shaft nut (1) using J 33022.
^
Hold the clutch plate and hub assembly (2) steady using J 33027.
2. Clutch plate and hub assembly (2).
^
Thread J 33013-A into the clutch plate and hub assembly (2).
Removing The Clutch Plate & Hub Assembly
^
Hold the body of J 33013-A with a wrench and tighten the center screw into the remover body.
3. Shaft key (21).
^
Retain shaft key (21) if usable.
Inspect
^
All pants and replace as necessary.
Install or Connect
Tools Required:
J 33026 Compressor Holding Fixture
J 33027 Clutch Hub Holding Tool
J 33022 6-Point 13 mm Socket
J 33013-B Hub and Drive Plate Remover and Installer