K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Rear Door Panel: All Technical Service Bulletins
Doors - Panel Poor Fit or Retention
BULLETIN NUMBER: 92-10A1-132
SECTION: 10A1
NUMBER: 1
CORPORATE REFERENCE NUMBER: 261613
DATE: September 1992
SUBJECT:
DOOR PANEL FIT/RETENTION (INSTALL NEW DOOR TRIM PANEL FASTENERS)
MODELS:
1988-92 C/K TRUCKS
Owners of some 1988-92 C/K models may experience poor door trim panel fit or lack of retention between the door trim panel and the door.
SERVICE PROCEDURE
Install new door trim panel retainers (P/N 15953247).
1.
Remove the trim panel pull strap (if equipped).
2.
Remove the door handle bezel.
3.
Remove the armrest screws. It is not necessary to remove the armrest from the panel.
4.
Remove the window handle (if equipped) using tool J9886-01 or equivalent.
5.
Remove the door trim panel.
-
Use tool J 24595-C or equivalent to remove the nylon fasteners from the inner door panel.
-
The Switch bezel will fit through the cut-out in the trim panel.
6.
Install the new retainers to the door trim panel (P/N 15953247).
7.
Install the door trim panel to the door
-
Put the door trim panel in place on the door and push the nylon fasteners into the holes on the door.
-
The switch bezel will fit through the cut-out in the door trim panel.
8.
Install the window handle (if equipped).
9.
Install the armrest screws.
10.
Install the door handle bezel.
11.
Install the pull strap (if required).
PARTS INFORMATION
Parts are expected to be available on 9/14/92. In case of limited inventory, parts will be placed on 400 control to waive VIP surcharges. Only verifiable
emergency orders will be accepted. GMSPO will make every effort to obtain parts. However, the part will be shipped premium transpohation at the
dealer's expense and all other order types will be placed on backorder until the 400 control is removed.
