K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Figure 3 - Adjust Thrust Bearing Preload
-
Adjust thrust bearing preload (Figure 3).
-
After adjusting thrust bearing preload, check the turning torque of the stub shaft (251) using J 7754-01 (0-25 lbs.in. torque wrench) and a
12-point socket. A torque reading of 5-10 lbs.in. is desired. If this reading is not obtained, repeat the adjustment procedure.
6.
Washer (243).
7.
Retaining ring (244).
Important
The retainer projections must not extend beyond the washer (243) when the retaining ring (244) is seated. The washer must be free to rotate.
8.
Steering gear to vehicle. Refer to section 3B1 of the appropriate C/K service manual for complete installation instructions.
SERVICE PARTS INFORMATION
P/N
Description
Year
Applications
26010052
Valve Assembly,
1988-91
All Models
Steering Gear
26010275
Seal Kit,
1988-91
All Models
Adjuster Plug
Parts are currently available from GMSPO.
WARRANTY INFORMATION For vehicles repaired under warranty use:
Labor Operation
Model
Labor Time
T7176
C
1.2 hrs.
