K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Paint: All Technical Service Bulletins
Paint - Checking Clear Coat Thickness
GMC NUMBER:
91-10-82
GROUP:
10 Body Section
DATE:
April, 1991
CORPORATE
NUMBER:
111701R
SUBJECT:
IMPORTANCE OF CHECKING CLEAR COAT THICKNESS BEFORE AND AFTER PAINT FINESSE OPERATIONS
MODELS:
1984 AND FUTURE TRUCKS WITH CLEAR COAT PAINT FILM
Finesse procedures ("Removal of Chemical Spotting and Other Minor Paint Imperfections Without Repainting") may result in a lowering of the clear
coat protective film below the level necessary to provide minimum durability and performance requirements. As time progresses, a severe "whitening" or
degradation of the clear coat may occur when the clear coat is removed below the minimum GM specification. GMC Truck recommends a paint
thickness gage be used to determine how much of the clear coat has been removed by the polishing or compounding process. Readings of the paint film
build should be taken prior to the finesse operation. As the finesse operation progresses, additional readings should be taken to determine the impact on
the total film build. If the gage indicates the total thickness has been reduced by .5 mils, it will be necessary to re-spray clear on the repair area to restore
the needed ultraviolet protection. If the base coat is disturbed, a complete repainting process is required. There are many types of paint thickness gages
available to the refinisher in today's market. The older magnetic-type gages, the best of which have a +/- 5% accuracy range, are not sensitive enough to
detect a .5 mil removal of clear coat. Most gages are confined to checking either a ferrous substrate (steel), or a non-ferrous metal substrate. At this time,
there is no viable gage for reading film thicknesses on a non-metallic substrate (such as plastic or rubber).
GMC Truck recommends the digital Elcometer 300 fn paint thickness gage, or equivalent, for its abiltiy to read film thicknesses on both ferrous and
non-ferrous metal substrates. With thickness standards included for recalibration purposes, this instrument is capable of reading film thicknesses within
an accuracy range of +/- 1%. The approximate cost of the unit is $1750. As an alternative unit for the refinisher who deals only with traditional steel
components, GMC Truck recommends the digital Elcometer 246 model, or equivalent. The gage demonstrates a +/- 3% accuracy range and comes with
thickness standards for recalibration. The approximate cost of this unit is $575. Other digital paint thickness gages are available from the suppliers listed
below which demonstrate the same accuracy levels as the recommended Elcometer models:
Elcometer, Inc.
Defelsko Corp.
1893 Rochester Ind. Dr.
410 Cedar Street
Rochester Hills, MI 48309
Ogdensburg, NY 13669
(800) 521-0635 or
(800) 267-0607 or
(313) 651-0500
(613) 925-5987
Zorelco, Ltd/Zormco
8520 Garfield Road
Cleveland, OH 44125
(216) 441-6102
We believe these sources, their equipment, and materials to be reliable. There may be additional manufacturers of such materials and equipment. General
Motors does not endorse, indicate any preference for, or assume responsibility for the products or equipment from these firms or for any such items
which may be available from other sources.
