K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Installing The Pulley Bearing Assembly
^
Position J 33017 and J 33023-A over the inner race of the bearing.
^
Position J 8433-1 on J 33023-A and assemble the through bolts and washers through the puller bar slots and thread them into J 34992.
-
The thread of the through bolts should engage the full thickness of the compressor holding fixture.
^
Tighten the center screw in J 8433-1 to force the pulley and bearing assembly onto the compressor front head (33).
-
If J 33017 become misaligned with the inner race of the bearing, back off J 8433-1 and relocate center, then continue installation.
4. Pulley bearing retainer (24) using J 6083.
5. Clutch plate and hub assembly (22).
Clutch Coil Assembly
