K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Pulley Rotor & Bearing Puller Installation
^
Install J 33020 into the slots in the rotor and rotate the puller. Remove the rotor and hub assembly.
3. Screw from the puller. leave the puller in the rotor.
^
Invert the puller and rotor assembly on a flat surface.
Bearing Removal
4. The bearing from the hub using J 9398-A and J 29886.
5. The staking metal.
Install or Connect
Tools Required:
J 6083 Snap Ring Pliers
J 9481-A Pulley and Bearing Installer
J 21352-A Support Block
J 25008-A Holding Fixture
J 29886 Driver Handle
J 33019 Bearing Staking Tool
