K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Engine Control Module: Service and Repair
When replacing a production ECM with a service ECM, transfer the broadcast code and production number from the production unit to the service unit.
Also, during replacement, the PROM, and if equipped, the CALPAK must be removed from the ECM being replaced and transferred to the new unit.
Refer to "PROM, REPLACE" and "CALPAK, REPLACE" for procedure.
1.
Disconnect battery ground cable.
2.
Remove right side kick panel, then disconnect two ECM electrical connectors.
3.
Remove ECM mounting hardware.
4.
Remove ECM from passenger compartment.
5.
Reverse procedure to install.
