K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Power Steering Pump: Service and Repair
Power Steering Pump Replacement
POWER STEERING PUMP REPLACEMENT
TOOL REQUIRED:
-
J 29785-A Puller
-
J 25033-B Pulley Installer
REMOVE OR DISCONNECT
-
Place a drain pan below the pump.
1. Hoses. Cap the hoses.
2. Loosen the tensioner assembly.
3. Belt.
4. Pulley (35).
-
Install J 29785-A. Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
-
Hold the pilot bolt.
-
Turn the nut counterclockwise.
5. Front brace (38) and rear mounting nuts (43).
6. Pump (33).
INSTALL OR CONNECT
1. Pump (33).
2. Rear mounting nuts (43).
TIGHTEN
-
Nuts to 23 Nm (17 lbs. ft.).
3. Front brace (38).
TIGHTEN
-
Bolts to 40 Nm (30 lbs. ft.).
-
Nut to 40 Nm (30 lbs. ft.).