K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
-
Adjust thrust bearing preload (Figure 3).
-
After adjusting thrust bearing preload, check the turning torque of the stub shaft (251) using J 7754-01 (0-25 lbs.in. torque wrench) and a
12-point socket. Combined torque reading (stub shaft bearing preload and pitman shaft preload) for the gear assembly must not exceed 20
lbs.in. (2.26 N-m). If this reading is exceeded, repeat the adjustment procedure. If necessary, refer to section 3B1A-4 (Unit Repair Manual)
for pitman shaft preload. Adjustment of 5-10 lbs.in. (0.57-1.13 N-m.) is desired. If this reading is not obtained, repeat the adjustment
procedure.
6.
Washer (243).
7.
Retaining ring (244).
Important
The retainer projections must not extend beyond the washer (243) when the retaining ring (244) is seated. The washer must be free to rotate.
8.
Adjuster plug locknut (245).
9.
Steering gear to vehicle.
-
Refer to section 3B1 of the appropriate C/K service manual for complete installation and system bleed procedure instructions.
