K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Removal Procedure For Torsion Bar Adjustment Assemblies On Both Torsion Bars (See Figures 1 And 2). Tool Required:
J 36202 - Torsion Bar Unloading Tool
1.
Raise vehicle front and support with suitable safety stands.
2.
Increase the tension on adjustment arm (186) using J 36202.
3.
Remove adjustment bolt (184) and retaining plate (185).
4.
Release tension on adjustment arm and move tool aside.
5.
Slide torsion bars forward.
6.
Remove the adjustment arms (186).
Replacement Procedure For New Torsion Bar Adjustment Assemblies On Both Torsion Bars (See Figures 1 And 2). Tool Required:
J 36202 - Torsion Bar Unloading Tool
1.
Fit the new torsion bar adjusting arms (Part # 15603963) on the torsion bars.
2.
Increase the tension on the torsion bar, using J 36202.
3.
Install the retaining plate and the adjustment bolt.
4.
Release the tension on the torsion bar until the load is taken up by the adjustment bolt.
5.
Remove J 36202.
6.
Lower the vehicle.
7.
Reset "Z" height and front end alignment to the specifications listed at the end of this bulletin.
SERVICE PARTS INFORMATION:
WARRANTY INFORMATION:
For repairs under warranty use:
Labor Operation:
T8130 Replace both torsion bar adjuster arms, set "Z" height, and check front wheel alignment.
Labor Time:
.9 hr.
Add:
To Align Front Wheels
-
K Trucks without cam kits previously installed. 1.2 hrs.
-
K Trucks with cam kits previously installed. .6 hrs
NOTE:
Labor operation is coded to base vehicle coverage in the warranty system.
