K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Pilot Bearing: Technical Service Bulletins
M/T - Clutch Pilot Bushing and Bearings
File In Section: 7 - Transmission
Bulletin No.: 46-73-02
Date: October, 1994
INFORMATION
Subject:
Clutch Pilot Bushings and Bearings
Models:
1988-95 Chevrolet and GMC Truck Light Duty Trucks with 4.3L, 5.0L, 5.7L, 6.2L, 6.5L, 7.4L Engines and Manual Transmission
A worn or damaged clutch pilot bushing or bearing, located in the end of the crankshaft, can be the cause of various clutch and transmission concerns
including:
^
Noise when the clutch pedal is depressed
^
Transmission noise
^
Clutch shudder on launch
^
Difficult shifting or excessive clash into reverse
A worn clutch pilot bushing will not properly support the transmission input shaft. Without sufficient support, the front of the input shaft can move out of
location resulting in transmission noise or clutch shudder on engagement.
A damaged clutch pilot bushing or bearing may continue to turn the transmission input shaft when the clutch is released. This rotation can then cause
difficult shifting or gear clash.
Anytime a transmission or clutch is removed for repair, a new clutch pilot roller bearing should be installed. The end of the transmission input shaft that
contacts the pilot roller bearing should also be inspected for damage.
When installing the pilot roller bearing, the chamfer or lead-in to the I.D. should be installed facing the rear of the vehicle. This chamfer will help guide
the input shaft into the roller bearing. This bearing is pre-lubed with a high temperature grease and does not require additional lubrication.
The bearing listed below will fit all 1988-95 4.3L, 5.OL, 5.7L, 6.2L, 6.5L, and 7.4L light duty engines. Do not use a bronze clutch pilot bushing.
Parts Information
P/N
Description
Qty
14061685
Bearing, clutch Pilot
1
Parts are currently available from GMSPO.
