K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Side Gear (RH) Clutch
Fig. 5 Exploded View Of Eaton Locking Differential
1.
Remove shim and disc pack from gear keeping components in order.
2.
Inspect discs and guide clips and replace as needed.
3.
Inspect side gear and shim. If either component is scored or excessively worn, inspect case and replace entire assembly if case is defective. If
either side gear or shim must be replaced, shim thickness must be determined as outlined in SIDE GEAR SHIM SELECTION.
4.
Alternately assemble splined and eared discs on side gear hub as shown in Fig. 5. If components are reused, they must be installed in original
position.
5.
Install original shim or new shim of equal thickness.
