K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
2. Nut using J 8614-01.
^
Position J 8614-01 on the flange so that the four notches on the tool face the flange.
3. Flange using J 8614-01.
^
Use the special nut and forcing screw to remove the flange.
4. Oil seal.
^
Carefully pry the seal from the bore. Do not distort or scratch the aluminum case.
Inspect
^
The pinion flange for a smooth oil seal surface.
^
The pinion flange for worn drive splines.
^
Replace if necessary.
5. Dust deflector.
^
Tap the deflector from the flange.
^
Clean up the stake points on the flange.
Install or Connect
1. Dust deflector on the flange.
^
Stake the new deflector at three new equally spaced positions. Staking must be such that the seal operating surface is not damaged.