K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
ASSEMBLE
1. Lubricate and install O-ring seal (56).
2. Thrust support assembly (49).
3. Adjuster nut (65) to housing (20) using J 7624.
4. Coupling shield ret. and lock nut (48) to adjuster nut (65). Adjust the thrust bearing preload.
5. Install coupling shield ret. and lock nut (48), and using a drift in a notch, tighten securely. Hold adjuster nut (65) to maintain alignment of the
marks.
6. Adjust the pitman shaft over-center sector.
7. Install or connect the power steering gear.
Valve Replacement