K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
-
Slide the support crossmember forward until the torsion bars are supported.
4. Adjustment arms on the torsion bars.
5. Bolts and nuts into the torsion bar support crossmember link assembly. Tighten to 125 Nm (92 ft. lbs.).
6. Adjustment retainer plate and bolt on both torsion bars.
-
Increase the tension on the torsion bar, using J 36202.
-
Install the retaining plate and the adjustment bolt.
-
Set the adjustment bolt to the marked setting 34 mm (1.3 inch).
-
Release the tension on the torsion-bar until the load is taken up by the adjustment bolt.
-
Remove J 36202.
7. Lower the vehicle. Check the "Z" height.