K 2500 Truck 4WD V8-5.3L VIN T (1999)
Clutch Slave Cylinder: Service and Repair
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement or Transmission Replacement.
2. Remove the two bolts securing the actuator cylinder to the clutch housing.
3. Remove the actuator cylinder from the transmission input shaft.
If required, the bearing can be removed from the actuator cylinder for replacement.
Installation Procedure
1. Position the actuator cylinder to the transmission input shaft.
Ensure that the bleed screw and the coupling are positioned toward the transmission ports.
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the actuator cylinder to the clutch housing with two bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.).
3. Install the transmission. Refer to Transmission Replacement or Transmission Replacement.