K 2500 Truck 4WD V8-6.0L VIN U (1999)
Cruise Control Servo Cable: Service and Repair
Cruise Control Cable Replacement
REMOVAL PROCEDURE
1. Remove engine sight shield.
2. Disconnect the cruise control cable locator clip from the outboard rectangular hole in the routing bracket at the left front corner of the engine.
3. Disconnect the cruise control cable conduit fitting from the round hole in the engine cable bracket.
4. Disconnect the cruise control cable engine-end fitting from the nail-head stud on the throttle lever.
5. Disconnect the cruise control cable fitting from the cruise control module.
6. Disconnect the cruise control cable bead from the fitting on the cruise control module ribbon.
7. Remove the cruise control cable from the vehicle.
INSTALLATION PROCEDURE
IMPORTANT: Secure all of the components of the accelerator and the cruise control cables as specified. Ensure that the throttle linkage operates
freely without binding between the idle position and the wide open throttle.
