K 2500 Truck 4WD V8-6.0L VIN U (1999)
3. Install the new O-ring seals (1) to the valve end of the cylinder lines.
4. Install the cylinder line assemblies (1) to the gear assembly (2).
NOTICE: Refer to Fastener Notice in Service Precautions
-
Tighten the valve end fittings to 16.9 Nm (12.6 ft. lbs.).
-
Tighten the cylinder end fittings to 27 Nm (20 ft. lbs.).
5. Refer to Bleeding Power Steering System.
IMPORTANT: Flush and bleed power steering system (hoses, reservoir and cooler lines) with power steering fluid GM Part #1050017 (or
equivalent meeting GM Specification #9985010).
Gear Stub Shaft Seals and Bearing Replacement - Off Vehicle
DISASSEMBLY PROCEDURE