K 2500 Truck 4WD V8-6.0L VIN U (1999)
IMPORTANT: Do not score the housing bore when prying out seals and washers. Remove the pitman shaft dust seal (3) from the steering gear
housing (1).
-
Inspect the housing for burrs and remove if necessary.
-
Insert J 6278 through the hole in the top of the steering gear housing (1).
-
Drive out the needle bearing (2) from the steering gear housing (1).
ASSEMBLY PROCEDURE
-
Tools Required
-
J 6278 Pitman Shaft Bearing Remover and Installer
-
J 4245 Internal Snap Ring Pliers
1. Install the needle bearing (2) into the steering gear housing (1) using J 6278.
2. Drive the bearing into the housing until the needle bearing shoulder seats against the housing.