K 2500 Truck 4WD V8-6.5L DSL Turbo VIN F (1994)
Figure 15
Figure 16
3.
If terminal is to be re-used, re-form locking tang (see Figures 12 through 16).
4.
Make repair.
When using a new terminal:
a.
Slip cable seal away from terminal (if seal exist).
b.
Cut wire as close to terminal as possible.
c.
Slip a new cable seal onto wire (if necessary).
d.
Strip 3/16" (5 mm) of insulation from wire.
Figure 17
e.
Crimp a new terminal to the wire (Figure 17).
f.
Solder with rosin core solder.
g.
Slide cable seal toward terminal (if equipped with a seal).
h.
Crimp cable seal and insulation (if equipped with a seal, see Figure 17).
i.
Apply grease to connectors outside the passenger compartment where the connector originally was equipped with grease.
To re-use a terminal or lead assembly, see previous steps c through i for repairs. Be sure to keep cable seal (if equipped) on terminal side of splice.
5.
Insert lead from the back until it catches.
Figure 18