K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
-
The O-ring on the vehicle speed sensor assembly
-
The vehicle speed sensor assembly
-
The bolt
-
Tighten the bolt to 22 Nm (16 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the electrical connector on the vehicle speed sensor assembly.
4. Lower the vehicle.
Vehicle Speed Sensor (NV 4500)
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lift Points.
2. Support the vehicle with safety stands.
3. Disconnect the electrical connector from the vehicle speed sensor assembly.
4. Place a suitable container under the transmission in order to catch the fluid.
5. Remove the following parts: