K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
Wiper Motor: Service and Repair
Rear Wiper Motor
REMOVAL PROCEDURE
1. Remove the wiper arm.
2. Remove four retainers from the wiper motor cover.
3. Remove the cover from the wiper motor.
4. Disconnect the electrical connector from the wiper motor.
5. Remove the bolt from the wiper motor.
6. Remove the nut from the liftglass.
7. Remove the nut, the spacer, and the washer from the wiper motor drive shaft.
8. Remove the wiper motor from the vehicle.
INSTALLATION PROCEDURE
1. Install the wiper motor onto the vehicle.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the washer, the spacer, and the nut on the wiper motor drive shaft.
Tighten
Tighten the nut to 6 N.m (53 lb in).
3. Install the nut in the liftglass.
4. Install the bolt to the wiper motor.
Tighten
Tighten the bolt to 6 N.m (53 lb in).
5. Connect the electrical connector.
6. Install the cover onto the wiper motor.
7. Install four retainers in the cover.
8. Install the wiper arm.
