K 2500 Truck 4WD V8-8.1L VIN G (2001)
34. Install the bypass valve vacuum hose (1) to the intake manifold.
35. Position the engine harness over the engine compartment.
36. Connect the following electrical connectors:
^
Generator (1)
^
Injector harness (2)
^
Ignition coil harness (3)
^
TP sensor (4)
^
ETC (5)
^
Purge valve solenoid (6)
37. Install the CPA retainer at the ignition coil harness.
38. Install the engine harness bolt and studs
^
Tighten the engine harness bolt to 5 Nm (44 inch lbs.).
^
Tighten the engine harness stud to 10 Nm (89 inch lbs.).
39. Connect the following electrical connectors: