K 2500 Truck 4WD V8-8.1L VIN G (2001)
7.
Replace the A/C compressor (2) with P/N 15081861. Refer to the Compressor Replacement LR4, LM7, LQ4, L18 w/Denso procedure in the
Service Manual (SI 2000 Document ID # 448700).
8.
Install the new suction hose, P/N 15065473, to the compressor (2) and to the accumulator. Refer to the Suction Hose Replacement LR4, LM7,
L04, L18 w/Denso procedure in the Service Manual (SI 2000 Document ID # 628200).
9.
Remove the retainer from the evaporator tube (2) to the air cleaner support bracket.
10.
Measure 152 mm (6 in) in front of the Y in the evaporator tube (2) and mark.
Important:
^
Denso DOES NOT RECOMMEND the use of SUCTION SCREEN FILTERS with Denso compressors.
^
Do not allow metal burrs to enter the evaporator tube (2) during cutting or when removing the burrs.
^
When you section the A/C lines, ensure that the correct minimum length remains in the straight part of the line on both sides of the filter.
11.
Using a tubing cutter, cut the marked section of the evaporator tube (2).
12.
Remove the burrs from the evaporator tube (2).
13.
Remove the nuts (4), the ferrules (3), and the 0-rings (2) from the A/C refrigerant filter (1).
Important:
Do not install the 0-rings (2) in this step.