K 2500 Truck 4WD V8-8.1L VIN G (2001)
Wheel Fastener: Service and Repair
Front
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Separating Tool
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the wheel stud from the hub flange using the J 43631.
4. Remove the wheel stud from the hub flange.
Installation Procedure
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the hub flange.
5. Remove the wheel nut.