K 2500 Truck 4WD V8-8.1L VIN G (2001)
Transfer Case Actuator: Service and Repair
Transfer Case - NVG 263-NP1 (Selectable)
Transfer Case Motor/Encoder Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the front propeller shaft.
4. Remove the motor encoder electrical connector.
5. Remove the motor encoder mounting bolts.
6. Remove the motor encoder unit from the transfer case.
7. Remove the motor encoder silicone gasket.
Installation Procedure
Important:
^
If the motor encoder assembly is being replaced because it is defective, make sure that the transfer case is in the neutral position. Manually shift
the unit at the shift shaft. Use a crescent wrench if necessary.
^
If the motor encoder is being replaced, a new gasket will come with the motor encoder. DO NOT use the old gasket.