K 2500 Yukon 4WD V8-6.0L VIN U (2000)
3. Close the cup holder by pushing back up into the rear of the floor console.
Cupholder Replacement (Non-Console)
Cupholder Replacement (Non-Console)
Removal Procedure
1. Tilt the cupholder down.
2. Remove the screws holding the cupholder to the instrument panel (IP).
3. Remove the cupholder from the vehicle.
Installation Procedure
1. Position the cupholder to the IP.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the screws holding the cupholder to the IP.
Tighten the screws to 2 N.m (18 lb in).
3. Return the cupholder to the up position.