K 2500 Yukon 4WD V8-6.0L VIN U (2000)
16. Install the center trim pillar moldings.
17. Carefully route the wire harness through the IP in order to connect the wire to the junction block located next the brake pedal.
18. Install the transfer case control module, if equipped.
Important: Please ensure that all of the wire harness retainers in the IP and the windshield pillar are all pressed into place in order to prevent
rattling during driving.
19. Press in the wire harness retainer (1) in order to secure the harness.
20. Connect the headliner electrical connectors to the junction block located next to the brake pedal.
Notice: Refer to Fastener Notice in Service Precautions.
21. Install the IP upper brackets.
Tighten
Tighten the IP upper bracket bolts to 9 N.m (80 lb in).