K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Engine Accessory Bracket: Service and Repair
Removal Procedure
1. Remove the generator. Refer to Generator Replacement.
2. Remove the power steering pump. Refer to Power Steering Pump Replacement.
3. Remove the accessory mounting bracket from the engine using the following steps:
^
Remove the bolts holding the accessory mounting bracket to the cylinder head and block.
^
Remove the bolt behind the power steering pump to engine block.
^
Remove the accessory mounting bracket.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the generator mounting bracket to the cylinder head using the nuts and the bolts.
Tighten the bolts to 50 Nm (37 ft. lbs.).
2. Install the power steering pump. Refer to Power Steering Pump Replacement.
3. Install the generator. Refer to Generator Replacement.