K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Air Door Cable: Service and Repair
Mode Control Cable Replacement
REMOVAL PROCEDURE
1. Remove the instrument panel (IP) bezel.
2. Remove the radio.
3. Remove the heater control assembly.
4. Disconnect the mode cable from the heater/ventilation module.
5. Remove the mode cable from the IP carrier.
INSTALLATION PROCEDURE
1. Install the mode cable to the IP carrier.
2. Connect the mode cable to the heater/ventilation module.
3. Install the heater control assembly.
4. Install the radio.
5. Install the IP bezel.