K 2500 Yukon 4WD V8-6.0L VIN U (2000)
![background image](/gmc/k_2500_yukon_4wd/v8-6.0l_vin_u/Page-2728005.png)
4.
Install a 3/8 inch drive wrench on the drive belt tensioner and rotate the arm counterclockwise.
5.
Remove the drive belt.
6.
Slowly release the tension on the drive belt tensioner.
7.
Remove the power steering pump pulley.
A.
Install the J 25034-C pulley remover.
B.
Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
C.
Hold the pilot bolt.
D.
Turn the nut counterclockwise.
8.
Remove the front mounting bolts.
9.
Remove the rear mounting nuts from the studs.