K 2500 Yukon 4WD V8-6.0L VIN U (2000)
3. Install the bolts to the frame bracket.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the nuts.
-
Tighten the bolts to 105 Nm (77 ft. lbs.).
5. Connect the (RTD) sensor. (if equipped). Refer to Rear Position Sensor Replacement - Electronic Suspension - Left (15 Series) or Rear Position
Sensor Replacement - Electronic Suspension - Left (25 Series) or Rear Position Sensor Replacement - Electronic Suspension - Right (25 Series) or
Rear Position Sensor Replacement - Electronic Suspension - Right (15 Series).
6. Remove the rear axle support.
7. Remove the safety stands.
8. Lower the vehicle.
