K 2500 Yukon 4WD V8-6.0L VIN U (2000)
Stabilizer Link: Service and Repair
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle.
3. Remove the stabilizer shaft fink nut and bolt from the frame bracket.
4. Remove the stabilizer shaft link nut from the ball stud.
5. Remove the stabilizer shaft link.
Installation Procedure
1. Install the stabilizer shaft link.
Important: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
2. Install the stabilizer shaft link nut to the ball stud.