K 2500 Yukon 4WD V8-6.0L VIN U (2000)
4.
Install the new washer check valve (1), P/N 22102237, in place of the straight connector. Install with the arrow pointing in the direction of fluid
flow.
5.
Install the lift gate trim panel.
5.1.
Position the trim panel to the lift gate.
5.2.
Slide the trim panel downward to engage the mounting hooks.
5.3.
Press on the trim panel in order to engage the retaining clips.
5.4.
Install the pull strap.
6.
Install the lift gate garnish molding.
6.1.
Install the molding to the lift gate.
6.2.
Press on the molding in order to engage the retaining clips.
6.3.
Install the pushpin retainers into the garnish molding.
6.4.
Close the lift gate window.
Caution:
This product should be used in a well ventilated area using nitrile gloves and proper eye protection. This product is flammable, do not use
around open flames. These reconditioning wipes may spontaneously combust, be aware of the risk. All personnel should read the Material
Safety Data Sheet before using this product. Proper disposal of used wipes should be followed.
Important:
Make certain that the surface is clean and dry before applying Armor-Dillo. This product will not bond to wet surfaces and, if the surface is not
clean, the results will not meet expectations.
7.
Apply Armor-Dillo following the procedure below.
7.1
Wash the vehicle with a general purpose cleaner to make certain the surface is clean.
7.2.
For ease of clean-up, tape off the painted or chrome bumper surface around step cover and remove the license plate if necessary.
7.3.
Apply Armor-Dillo evenly over the surface.
7.4.
Allow the product to remain on the surface for a few minutes.
Important:
If this step is not performed, this product will remain tacky and will attract dirt.
7.5.
Use a damp lint free towel and wipe the treated surface thoroughly.
