K 3500 Truck 4WD V8-393 6.5L DSL Turbo VIN S (1995)
1.
Attach the inboard center section of the liner to the inboard center section of the fender first. Remove a small section of the protective wax paper
on the inboard center section of the liner to expose the adhesive layer of the fender liner. Using moderate pressure, apply the top fender liner to the
inside top of the fender as illustrated (Figure 1). Carefully peel the wax paper from the center of the liner toward the front and rear of the fender
attaching the liner as you go. Repeat this process to the opposite fender.
2.
Apply the rear fender liner to the inside rear of the fender as illustrated (Figure 1). Take care to overlap the rear liner on the top liner as illustrated.
Repeat this process to the opposite fender.
3.
Apply moderate pressure to the entire surface of the fender liners to insure good adhesion to the inside of the fenders.
Parts Information
Part quantity reflects the number required to do both fenders on one vehicle.
P/N
Description
Qty
15741040
Protector-rear
2
fender upper
15741041
Protector-rear
2
fender rear
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Op
Description
Labor Time
B8340
Install fender liner,
0.3 hr
right side