K 3500 Truck 4WD V8-454 7.4L VIN J SFI (1996)
3. Pivot the cage and the inner race 90° to the center line of the outer race. At the same time, align the cage windows with the lands of the outer race.
Lift out the cage and the inner race.
4. Remove the inner race from the cage by rotating the inner race upward.
5. Thoroughly degrease all of the CV joint parts.
6. Check the CV joint assembly for unusual wear, cracks, or other damage. Replace any damaged parts.
7. Clean the axle shaft. Use a wire brush to remove any rust in the-seal mounting area (grooves).
Assemble CV Joint and Seal
-
Required Tools:
-
J 35910 Seal Clamp Tool
-
J 36652 Swage Clamp Tool
-
J 36652-1 Split Plate Swage Clamp (K10/K20 models)
-
J 36652-2 Split Plate Swage Clamp (K30 models)
1. Inspect all of the parts for unusual wear, cracks, or other damage. Replace the joint assembly if necessary.
2. Put a light coat of the recommended grease on the inner and the outer race grooves.