K 3500 Truck 4WD V8-5.7L VIN R (1998)
4. Remove the propeller shaft.
5. Clean the propeller shaft, universal joints, and attachments with an approved solvent.
INSTALLATION PROCEDURE
1. Install the propeller shaft.
2. Install the bolts and retainers.
-
Tighten the bolts to 20 Nm (15 ft. lbs.).
-
Tighten the bolts 37 Nm (27 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
Propeller Shaft Replacement - One-Piece
REMOVAL PROCEDURE
1. Reference mark the propeller shaft to pinion flange connection.
IMPORTANT: Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly.
These components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. All components must be reassembled in the exact
relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements made
prior to disassembly must be followed.
2. Reference mark the slip yoke to the transmission for proper reassembly.
3. When servicing driveshafts with the pop on seal, do not remove the seal from the sleeve. Removal of the seal causes damage to the seal lip where
it contacts the sleeve yoke. If removal of the seal is necessary, replace the seal with a new unit.
4. Remove the bolts.
