K 3500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
31.
Apply the parking brake in order to prevent the vehicle from moving.
32.
If equipped with an automatic transmission, move the shift lever all the way down to the last gear.
33.
Tilt the steering wheel to the full down position.
34.
Pull gently rearward on the corners of the bezel from the IP assembly.
35.
Remove the bezel.
36.
Remove the knee bolster trim panel screws.
37.
Unsnap the knee bolster.
38.
Twist the brake release cable in order to disengage the knee bolster.
39.
Disconnect the lap cooler hose from the knee bolster trim.
40.
Remove the tour knee bolster retaining nuts.
41.
Loosen the screw holding connector C201 together and separate. C201 is the connector for the steering column wires to the IP wiring harness on
the left side of the column about half way down. It is a 48-way connector with a center retaining screw.