K 3500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2001)
Control Module: Service and Repair
NVG 236/246-NP8
Transfer Case Shift Control Module Replacement
1. Remove the IP trim bezel.
2. Pull out the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly in order to disconnect the electrical connectors.
3. Disconnect all the electrical connectors from the lamp switch, cargo lamp and 4WD shift buttons assembly.
4. Remove the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly from the vehicle.
5. Remove the electrical harness retainer from the IP support beam.
6. Disconnect the 2 electrical connectors from the transfer case shift control module.
7. Move the electrical harness to the left side in order to make room to turn the transfer case shift control module.
8. Rotate the transfer case shift control module about 45 degrees counter clockwise while pulling out at the same time until the module is
approximately 90 degrees from the original position.
9. Pull out the module from the vehicle.
Installation Procedure
